Gasoline engine:
-power 6 HP
-self-winding pull start
(In a few minutes you can quickly replace gasoline engine with electric
motor. Look at optional)
Hand push
Parking brake on rear wheel
Swivel front wheel, to stripe very sharp curves. It can be locked or
unlocked during the work by a lever on handlebars. Steering hardness is
adjustable by proper regulator
Telescopic pointer for easily following pre-marking or precisely matching
existing line
Handlebars with adjustable height
Equipment with:
- nozzle for line width 5 cm
- nozzle for line width 30 cm
- nozzle for surfaces, advised for stenciling (crosswalk, symbols, legends, stops, …).
- HMC-C Hydraulic Motorized Chariot with Compressor:
transforms the push machine in a machine with drive.
Electronic spacing device C8000:
8 programs storable
control: upto 3 guns with only one program
alarm when speed is outside the range of minimum/maximum speed set
data recorded for each gun: total solid line metres
total data recorded for machine: total driven Km
- Automatic paint gun with control.
- Second automatic paint gun with independent control, to stripe 50 cm or 2 lines at the same time
- Pneumatic support for paint gun (one disc), to keep automatic gun always at the same distance from ground, ensuring
constant width of the line.
- Pressurized glass bead system consisting of:
glass bead tank. Available capacity: - pressurized tank capacity 15,5 l
- pressurized conic tank capacity 20 l
- pressurized tank capacity 26 l
automatic glass bead gun with adjustable diffuser
closing delay regulator for bead gun.
- Second automatic glass bead gun with independent delay regulator.
- Manual glass bead gun with air hose and bead hose, for bead application on stenciling.
Български
English
Русский
Român
Ελληνικά
Italiano
Write a review: